16PCS DC Boost Converter Constant Module Current Mobile Power Supply 250W 10A LED Driver Non-isolated Step Up | Освещение

16PCS DC Boost Converter Constant Module Current Mobile Power Supply 250W 10A LED Driver Non-isolated Step Up | Освещение

16PCS DC DC Boost Converter Constant Module Current Mobile Power Supply 250W 10A LED Driver Module Non-isolated Step Up Module   Specification: Module nature: non-isolated step-up module (BOOST) Input voltage: DC 8.5V-48V Input current: 10A (MAX) more than 8A or module temperature over 60 degrees Please strengthen the heat Static operating current: 10mA (12V liters 20V, the higher the output voltage quiescent current will increase) Output voltage: 10-50V continuously adjustable (default delivery) Boost module, suitable          for application of input voltage is less than the output voltage can not buck Output current: 10A MAX more than 6A please strengthen the heat (with the input and          output pressure, the greater the greater the smaller the output current) Constant current range: 0.2-8A Output power: = input voltage * 10A, such as: input 12V * 5A = 60W, input 24V * 5A = 120W,          input 36V * 5A = 180W, input 48V * 5A = 240W Potentiometer: CC is constant current regulation; CV is constant pressure regulation. Operating temperature: -40 ~ +85 degrees (when the ambient temperature is too high, please strengthen the heat) Operating frequency: 150KHz Conversion efficiency: up to 96% (efficiency and input, output voltage, current, pressure related) Overcurrent protection: Yes (input more than 13A, automatically reduce the output voltage, there is a certain range of errors.) Input reverse polarity protection: Yes, (less than 5A if you need more reverse current in the input string into the diode) Installation: 4 3mm screw holes Wiring method: wiring output, VIN + for the input positive, VIN- for the input negative;          OUT + for the output positive, OUT- for the output negative. Module size: length 70mm wide 36mm high 16mm Module weight: about 50 grams   Output voltage / current regulation method: Adjust the CV potentiometer, depending on your battery or LED, set the output voltage to the voltage you need. Such as 10 string LED voltage regulation 37V. Clockwise adjust the CC potentiometer 30 or so, the output current is set to minimum, connected to the LED, adjust the CC potentiometer to your current. For the battery charge, the battery after the end of the battery, and then received the output, adjust the CC to the current you need (for charging must be used when the battery is fully charged, because the battery remaining power More, the smaller the charging current.) Please do not use short-circuit way to adjust the current, step-up module circuit structure can not be short-circuit way to tune.   Applications: DIY a power supply, input 12V can, the output can be 12-50V adjustable. Power your electronic device and set the output value according to your system voltage. As a power supply for the car, for your laptop, PDA or a variety of digital products. DIY a high-power notebook mobile power: coupled with a large capacity of 12V lithium          battery pack, so that you can go where the books where you can light up   Solar panel regulator. To the battery, lithium battery and other charges. Drive high power LED lights.   Package includes: 16pcs Boost Converter