AC85V-280V 3000W Wide Voltage input Full RF Wireless Remote Control Switch Receiver Transmitter Big wiring terminal | Обустройство

AC85V-280V 3000W Wide Voltage input Full RF Wireless Remote Control Switch Receiver Transmitter Big wiring terminal | Обустройство

1. Switch-mode power supplies reduction voltage electric circuit: it use the USA Power Company
Switch-Mode Power IC LNK304 to control the Power .Quality Assurance,stable,durable .

2. Super High Power , Using the BSO Bo Song Le 30A Relay .it can make sure to control the
high power applicance for a long time .it suggest to control the power about
4000W (Resistive Load ) 3000W ( Inductive Load ) Less than 3000W ( Motor Load ) .

3. Wide Voltage Input Range :it can be use between AC 85V-260V voltage.be sure
it can work stably in different voltage enviroment .

The Wireless Switch materials is sufficient .the circuit board is the double-side and high quality PCB ,
The power parts have been used the USA Orignal LNK304PN. The professinal Power Supply IC Chip ,
Stable performance and low power dissipation .it have been made sure the stability of the power.
it is not only suitable different input voltage of foreign country and where the voltage is unstable.
the performance is much perfect than the cheap resistive and capacitive pressure relief circuit .
the safety resistor and voltage dependent resistor have been protect circuit board effectively.
it is highly improve the working life.

Working Voltage :85V-260V
Output : ON-OFF output (switching value) (default) / 220V (to connect by the soldered dot on the receiver board .
or the guide line )

Working Voltage:AC85V-280V
Receiving Sensitivity:-105dB
Contact Capacity: 30A/250VAC;30A/30VDC
Working Frequency :315MHZ
Transmitting distance :10-200m


Learning Method :

Close all by one button

Input AC220V ,The LED Light ON,when the LED ON press the learning button for one time ,the LED will turn OFF to ON .

Then stay ON .When the Led indicator is OFF ,The receiver enter into Learning State,then press the learning button
on the receiver board ,when the LED flash for one time ,then press the relative button of thr transmitter ,

Open all by one button

Input AC220V ,The LED Light ON,when the LED ON press the learning button for one time ,the LED will turn OFF to ON .
Press the Learning Button again.the Led from OFF to flash for a time .(also say input then press 2times )then the LED
will OFF itself .it is entering learning status.press the learning button for 1 time again,it flash then press
the transmitter any button .the LED flash again.it mean have been learn successfully.

Normally Learning

Press the learning button for 2 seconds .the Led ON .then press the transmitter button .the LED will flash .
it mean have been learn successfully,if you have been press the learning button .while 15 seconds later you
still have`t press the transmitter button ,it will recover the orignal status,

Clear Code
Normally input .press the learning button continus more than 8 seconds until the Led ON from OFF .
Loosen your finger on the button .about 5 seconds .the Led ON and OFF again .it means have been cleared successfully.

Output State:

Non-Latched/Momentary:

Press the button is ON .Lossen your finger on the button is OFF . 1CH need 1 Button controller .

Self-Lock /Toggle:

Press one button for one time is ON .press the same button again is OFF . 1ch need 1Button controller .

Inter-lock/Latched :

Press one button is ON press another button is OFF .1ch need 2Button controller .

Notice :

Please tell us what output state do you want after you pay it .or we will ship Toggle as .default

package included:
1*receiver (included cover)
1* transmitter (included battery)