Pump stove additional lunfei liquid 12 v 24 lfbros | Автомобили и мотоциклы

Additional pump heater lunfei (analog pump Bosch).

If the stove is cool air-you need to install an additional pump. The installation is made in series with the heater. Connection-parallel to the heater fan. Thus, as soon as the heater fan works-an additional pump will immediately work, providing the flow of antifreeze (tosol) through the heater.
The reliability of the pump is achieved by the fact that the pump lunfei does not have a oil seal (seal), and the moment of rotation on the shaft of the impeller is is

When you order, please choose:
Required voltage 12 or 24 in.
And the diameter of the pump pipes is 16 or 20mm.

Can be used with pre-start and Webasto type heaters as a circulating pump.
Specifications:

• Dimensions overall-110x70x120mm

• Connecting diameter of the pipes (the inner diameter of the hoses-16 li 20mm

• Working mode-continuous

• Operating temperature of liquid- -40 .... + 100 deg. Celsius

• Work (nominal) voltage-12 or 24 in the current permanent

• Power consumption-2,4...14,4 W (depending on the supply voltage and load)

• Feed (flow rate) - 10 L/min or 600 L/H

• Current consumption-12v: 0,2...1,2 A; 24v: 0,1...0,6 a

• Pressure (lifting height of water or liquid at 1000 kg/CBM density) -2 m

• Sound pressure level (noise) - =< 40 dB

• Protection class-IP44

• Possibility of feeding from the on-board network, battery, power supply

• Application-pumping a car cooling system

• Pump weight without Package (net) - 0,4 kg

• 
  Specifics of the design:

1. Zirconia ceramic shaft

2. Electronic control with stability of rpm under load with Hall sensor control

3. Immersed in liquid rotor with radial magnet (brushless and oil-free design). Shaft oil seal-missing. The rotor is driven by a running magnetic field. The speed is controlled by the Hall sensor.

4. Possibility of arbitrary switching without reducing the service life (on/off of any duration with any pauses)

5. Soft rubber shock absorber with metallized hole (for attachment)

6. Red Wire "+", Black Wire "-", re-pole is not allowed

7. Impeller bearings-ceramics

8. Eliminate the use of contaminated pumps to avoid jamming the impeller of pumps.

Application:

• Additional pump to increase the flow of the air to the regular heater/heater of the cabin

• Replacement of standard pump of autonomous heater type Webasto/ebershpacher or other